Guide: How to remove Air bubbles

When you install PanzerGlass™ screen protection on your smartphone, you might experience air bubbles between the screen protector and the screen.

It is easy to remove these bubbles by lifting the screen protector from the screen. You can lift it off completely or partly depending on how many and large the bubbles are. 

You do not need to worry about lifting or removing the screen protector after the first installation. Our adhesive can withstand being reinstalled several times without harming how well the screen protector will stick to the phone.

Please follow this guide to remove air bubbles. Below the video you can also read the step by step guide. 

 

 

 

Step by Step Guide: How to remove airbubbles 

Step 1: Localise the air bubble or bubbles

Step 2: Gently lift the screen protector at the nearest corner. You can use a fingernail to make the screen protector let go of the screen. Lift and loosen the screen protector so much that the air bubbles are gone. If you have many air bubbles you can remove the screen protector completely. If you remove it completely, make sure not to turn it around, but make sure the adhesive surface is facing the phone all the time. By doing this you will limit the risk of dust on the adhesive. 

Step 3: Place the screen protector on the phone again and let it set. 

 

We hope that this guide has helped you removing the air bubbles. If you have any further questions, you are always welcome to contact our customer care team. 

On our webshop you can find a broad range of screen protection and mobile cases.